15173 Autoloader ALE: timeout moving unload cylinder Platesetter_3244 Check that the unload sensors indicating Extended (lowered) is working. as for 1. Check that the unload sensors indicating Retracted (raised) is working. Resume. Call Creo service if problem persists. When the unload cylinder is raised during an unload, if the unload cylinder has not left the lowered (extended) position within unload_delay seconds then this error is generated. In the ale_lower_unload() function the error is generated if the unload cylinder has not arrived at the lowered (extended) position withing unload_delay seconds. ale_lower_unload() is used during initialisation, unload, process and time table. In the ale_raise_unload() function the error is generated if the unload cylinder has not arrived at the raised (retracted) position withing unload_delay seconds. ale_raise_unload() is not used as this time. ../nvs/al_cal_nus.xmlNVS: al nus ../nvs/aldly_cal_uldly.xmlNVS: aldly uldly ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:54 2008 PST